Install Data Migrator
Ready to install? Check the prerequisites and then follow these steps to get up and running with Data Migrator.
Install Data Migrator
Install Data Migrator and upload to your chosen host. If you're migrating from Hadoop Distributed File System (HDFS), install Data Migrator on an edge node in the Hadoop cluster. Run the following installation command:
Make the installation script executable and install as the root (or sudo) user. These commands assume that the installer is inside your working directory.
chmod +x livedata-migrator.sh && ./livedata-migrator.shKnown issue
On CentOS 6, start the
livedata-uiservices manually. See System service commandsAlternative /tmp directory
The Data Migrator installer extracts its contents to a temporary directory and decompresses them. By default, the temporary directory is a sub-directory of
In some situations, extracting and decompressing in the default temporary directory fails. For example, if there is not enough disk space remaining, or if
/tmpis mounted as
To avoid these issues, extract the contents to a different temporary directory by adding the
--targetoption when you run the installer:Example
./livedata-1.21.0-4-full_rpm_installer.sh --target /opt/wandisco/alternate_tmp_dir
Do not use
/opt/wandisco/tmpas the value for
--targetor the installation will fail.
You can delete your temporary directory and its contents after installation.
Check the status of each service:Run the following command for each of the services, listed below
systemctl status <service name>
The service names are: livedata-migrator, hivemigrator, and livedata-ui.
If your system is running without systemd the commands use a different form.
System and custom users for installation
To run the installer using a default user, run the following command:
|Component||Default system user||Default system user group|
To install the product using a custom user or a custom user group, run the following commands:
./livedata-migrator.sh --user <custom user> --group <custom group>
./livedata-migrator.sh -- --user <custom user> --group <custom group>
This sets the custom user and custom user group for all services and their respective directories.
For more information about configuring custom users, go to Configure system users.
Install Data Migrator components on separate hosts
To install the components on separate hosts, run the following commands:
Install the UI on one host
./livedata-x.x.x-xx-full_rpm_installer.sh --noexec --keep
rpm -ivh livedata-ui-<version-number>.noarch.rpm
Install Data Migrator, Hive Migrator, and WANdisco CLI on one host
./livedata-x.xx.x-xx-full_rpm_installer.sh --noexec --keep
rpm -ivh livedata-migrator-<version-number>.noarch.rpm
rpm -ivh hivemigrator-<version-number>.noarch.rpm
rpm -ivh livedata-migrator-cli-<version-number>.noarch.rpm
Once you have Data Migrator running, you're ready to get started.