Skip to main content
Version: 1.17.1

About Preview Features

Preview features are LiveData Migrator features that are still under development and are subject to improvement. Currently Backup and Restore and Migration Verifications need to be enabled before you can use them. The steps to enable these two preview features are covered below.

Using a preview feature and have feedback to share? Contact WANdisco

Preview features - need enabling#

You may check which preview features are currently active with the following curl command:

Command
curl localhost:18080/preview

The command will return information similar to the following:

Output
curl localhost:18080/preview{  "preview/<feature>" : "OFF",  "preview/<feature>" : "OFF"}

Preview features are LiveData Migrator features that are still under development and are subject to improvement. These are disabled by default, and must be enabled in the properties file:

/etc/wandisco/livedata-migrator/application.properties

Preview features must be enabled by finding the corresponding property with the prefix preview.feature. and changing the OFF value to ON. For example:

Example for enabling Backup & Restore
preview.feature.backup-restore=ON

LiveData Migrator must then be restarted for the changes to take effect:

service livedata-migrator restart

Preview features - automatically enabled#

The following preview features are automatically enabled when you install LiveData Migrator: